Smart Wiring Multiple Fluorescent Lights

If you put devices in series they will share the voltage say 70 volts to one device and 50 volts to the second adding up to the 120 volts in the circuit.

Wiring multiple fluorescent lights. If you want do it yourself diy you can buy all the parts individually. Run a length of two conductor wire from the existing fluorescent fixture to the new fixture. Each lamp is connected to the next one i e.

There s nothing special about fluorescent lights. Switches and fuses must be connected through line live wire. The wire size should be no less than 14 gauge.

The l line also known as live or phase is connected to the first lamp and other lamps are connected through middle wire and the last one wire as n neutral connected to the supply voltage then. The wiring process of fluorescent tube lamp light with ballast starter is quite easy and simple. Continue to repeat this step for the remainder of your fluorescent fixtures in.

In most cases when we buy a fluorescent light it comes in a complete set with all wire connected. More current needed when additional light bulb added in the parallel circuit. Repeat the connections with the white wires and the bare copper wires.

In above fig all the three light points are connected in series. If the light table is in a commercial style. Feed the ends of the wire through the cable clamps and tighten the screws until the wire is secure.

Connecting electrical devices and appliances like. This is so that the full 120 volts is presented to each device. Neither device is likely to be happy.